Setdumpdirectory – Dell Emulex Family of Adapters User Manual
Page 1379
OCM for VMware vCenter Version 10.2 User Manual
P009805-01A Rev. A
11. Using OneCommand Manager for VMware vCenter Command Line Interface
The Command Reference
1379
setdriverparamdefaults
Description
This command restores the driver parameter to the default value at the port or global
level, either permanently or temporarily for the specified port.
Parameters
setdumpdirectory
Syntax
elxvcpcmd.exe v=
setdumpdirectory
Description
Use the setdumpdirectory command to set the dump directory for a given FC/FCoE,
NIC or iSCSI port. To use the SetDumpDirectory command, you must have a directory
mapped under /vmfs/volumes/ where the files will be placed.
Note: The dump directory applies to all adapters in the server. There is no separate
dump directory for each adapter.
Parameters
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
The WWPN of a port on the ESXi host with Emulex adapters.
MAC
The MAC address of the NIC port.
Flag1
L = Local (all adapters on this host)
G = Global (all adapters on this host)
Flag2
P = Permanent (persists across re-boot)
T = Temporary.
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
The WWPN of a port on the ESXi host with Emulex adapters.
MAC
The MAC address of the NIC port.
DumpDirectory
The directory under /vmfs/volumes that you created to store the
dump files.