Dell Emulex Family of Adapters User Manual
Page 905
Emulex Drivers Version 10.2 for Linux User Manual
P010081-01A Rev. A
4. Troubleshooting
Log Messages
905
0406: Adapter maximum temperature exceeded
offline
The driver has received an error for the HBA indicating that the maximum allowable temperature
has been exceeded.
Data:
(1) work_hs (2) work_status[0] (3) work_status[1]
Severity: Error
Log:
LOG_INIT
Action:
Ensure the server fans are not blocked. Shut down the server if the airflow is restricted.
0407: Ignoring nodev_tmo module parameter because devloss_tmo is set.
Both module parameters (nodev and devloss) were set so the driver is ignoring the nodev parameter.
Data:
None
Severity: Error
Log:
LOG_INIT
Action:
Only one of these parameters must be set.
0410: Cannot find virtual addr for mapped buf on ring
The driver cannot find the specified buffer in its mapping table. Therefore, it cannot find the virtual
address needed to access the data.
Data:
(1) phys (2) next (3) prev (4) postbufq_cnt
Severity: Error
Log:
Always
Action:
This error could indicate a software driver or firmware issue. If this issue persists report
these errors to Technical Support.
0421: MSI-X slow-path request_irq failed
The kernel API to request an IRQ has failed.
Data:
None
Severity: Warning
Log:
LOG_INIT
Action:
Use module parameter lpfc_use_msi=0 (INTx).
0422: lpfc_restrict_login attribute cannot be set to
[0, 1]
Attempt to set the restrict login parameter to something other than on or off.
Data:
None
Severity: Error
Log:
LOG_INIT
Action:
Use 0 (Off) or 1 (On)
0423: lpfc_"#attr" attribute cannot be set to %d, allowed range is ["#minval",
"#maxval"]
This is a compile time macro that is used by several module parameters during initialization. Each
module parameter has its own minimum and maximum values that are displayed.
Data:
None
Severity: Error
Log:
LOG_INIT
Action:
Set the module parameter between the minimum and maximum values.
Table 4-4 LPFC Error Log Messages and their Descriptions (Continued)