Dell Emulex Family of Adapters - Manual (Page 1550)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
3. Configuring PXE Boot for NIC on OCe14000-series Adapters
Using the PXESelect Utility
1550
Selecting a Port
Once you have set the options in the Configure Controller screen, ensure that you have
saved your changes. To save the current settings, press .
To proceed to the Port Selection menu:
1. From the Configure Controller screen, press . The Port Selection Menu
appears.
Figure 3-13 Port Selection Menu
Note: The Port Selection Menu only appears if there are two or more ports
connected.
2. Use the up or down arrow keys to select the port you want to configure and press
. The Port Menu appears.
Figure 3-14 Port Menu Screen
The Port Menu screen enables you to perform the following tasks:

Configure multichannel options – see “Configuring Multichannel Options” on
page 1551 for instructions.

Configure boot options – see “Configuring Boot Options” on page 1544 for
instructions.

Configure port options – see “Configuring Port Options” on page 1545 for
instructions.