Delta RMC151 - Manual (Page 680)

RMC70/150 and RMCTools User Manual
Count Data Length 8 to 31 bits
Control Outputs
Range ±10 V @ 5 mA (2 kΩ or greater load)
(For current output, use the VC2124 accessory:±10 mA to ±200
mA in 10 mA steps)
Tolerance At 10 V: +200 mV, -100 mV
At 0 V: ±50 mV
At -10 V: +100 mV, -200 mV
Resolution 12 bits
Output Isolation 500 VAC, optically isolated
Overload Protection One-second short-circuit duration
Overvoltage Protection Outputs are protected by clamp diodes
LEDS
Axis 0 LED
Axis LED applies to the Drive 0 output or feedback input 0 as described below:
1. If Drive 0 is assigned to an axis that has an input (i.e. isn't output-only), then that
axis will own the Axis 0 LED.
2. Otherwise, if a reference input axis (no output) uses input 0, then that axis will own
the Axis 0 LED.
3. Otherwise, if Drive 0 is assigned to an output-only axis, then that axis will own Axis 0
LED.
Axis 1 LED
Axis 1 LED applies to the Drive 1 output or feedback input 1 as described below:
1. If Drive 1 is assigned to an axis that has an input (i.e. isn't output-only), then that
axis will own the Axis 1 LED.
2. Otherwise, if a reference input axis (no output) uses input 1, then that axis will own
the Axis 1 LED.
3. Otherwise, if Drive 1 is assigned to an output-only axis, then that axis will own the
Axis 1 LED.
LED Colors
State Description
Steady
Off
No power or the output/input is not assigned to an axis.
Steady
Green
The axis is either in closed loop control or is a reference axis. The axis is
not halted.
Flashing
Green
The output is in open loop and the axis is not halted (not possible for
reference axes).
Flashing
Red
A Closed Loop Halt or External Halt has occurred because an error bit is set
(not possible for reference axes). The LED will not turn red due to a halt
caused by a halt command.
Steady
Red
An Open Loop Halt or Direct Output Halt has occurred because an error bit
is set (for reference axes, any halt has occurred). The LED will not turn red
due to a halt caused by a halt command.
7.3.7. Quadrature Module
660 Delta Computer Systems, Inc.