Delta RMC151 User Manual
Page 1176
RMC70/150 and RMCTools User Manual
To minimize electrical interference:
•
-In and Cmn must be connected. This connected should be made as close to the
transducer as possible.
•
Use individually shielded twisted-pair wire.
•
Typically, the cable shield should be connected to earth on one end only.
Current 4-20mA, 2-Wire
Note:
The Analog (G) Module does not support current feedback.
Notes:
•
The Res and -In pins are internally connected via a 250 Ohm resistor.
•
To minimize electrical interference, use individually shielded twisted-pair wire.
1156
Delta Computer Systems, Inc.