Delta RMC151 - Manual (Page 226)

RMC70/150 and RMCTools User Manual
4.5.2. Connection Path
To access this dialog:
Right-click the desired controller in the Project pane and choose Connection Path.
Or:
On the Controller menu, click Connection Path.
The Connection Path specifies how RMCTools connects to the RMC.
Connection Methods
The following connection methods are possible for the RMC:
Controller Connection Methods
RMC75E USB, Ethernet
RMC75S Serial Port
RMC75P Serial Port
RMC150E USB, Ethernet
To Select a Connection Path
1. In the Project Pane, right-click the controller you wish to connect to and click Connection
Path.
2. Choose the connection type:
• Ethernet
a. Click Browse to choose an RMC.
b. Choose your RMC from the list, or enter an IP address in the IP Address
box.
c. Click OK.
If your RMC appears in the list, but has an IP Address of 0.0.0.0, click
Configure Device to configure it's IP settings.
If your RMC does not appear in the list, see the Troubleshooting Ethernet
topic for help.
• USB
a. Click Browse to choose an RMC.
b. Choose your RMC from the list.
c. Click OK.
If your RMC does not appear in the list, verify that the USB cable is
connected.
• Serial
a. Choose the COM port.
b. Click OK.
1.
3. Click OK to apply the changes, or click Go Online to apply the changes and go online.
4.5.3. Go Online, Go Offline
The Go Online command in RMCTools connects RMCTools to an RMC. The Go Offline
command stops communication between RMCTools and the RMC.
206 Delta Computer Systems, Inc.