Delta RMC151 - Manual (Page 318)

RMC70/150 and RMCTools User Manual
RMC75P
(2.1F or
newer)
3.31.0+ 3000µs 1000µs 500µs/250µs
(note 3)
210 µs
(note 1)
--
RMC75P
(2.1E or
older)
3.31.0+ 3000µs/2500µs
(note 4)
1000µs/600µs
(note 5)
250µs
(note 1)
-- --
Note 1: These loop times are only supported in certain controller configurations. See
the loop time topic for details.
Note 2: If the RMC150 has 3 or fewer axes with any number of reference axes, or 4
control axes with up to 2 reference axes, 500µs is allocated. Otherwise 400µs is
allocated.
Note 3: If the RMC75S/RMC75P has 1 control axis with up to 3 reference axes, or 2
control axes with no reference axes, 500µs is allocated. Otherwise, 250µs is allocated.
Note 4: If the RMC75P has 1 control axis with up to 1 reference axes, 3000µs is
allocated. Otherwise, 2500µs is allocated.
Note 5: If the RMC75P has 1 control axis with up to 1 reference axes, 1000µs is
allocated. Otherwise, 600µs is allocated.
5.9. Programming Security
Programming Security is intended to be a means of password-protecting your intellectual
property. If you wish to prevent others from accessing the user programs you write, you can
enable the Programming Security feature.
Delta reserves the right to disable or bypass security features enabled by the copyright holder
of user programming in RMC series controllers. Delta’s responsive customer support is an
important service that benefits the customers. In order to ensure responsive service, Delta
reserves the right to disable or bypass any and all security features applied to the user
programming downloaded to an RMC series controller. For details on when and how Delta will
do this, refer to the RMCTools Security Policy and Agreement.
The Programming Security applies to the items in the Programming node of the Project
Pane. The protection can be applied to an online or offline project. When password-protected
programming is downloaded to the RMC, it will be protected in the RMC also. This means that
when a password-protected project is uploaded from the RMC, the programming will be
protected as specified in the original project.
RMCTools offers three levels of User Source Code Security:
1. Copyright Notice
This level will apply a copyright notice to the Programming. The contents of the
Programming node will still be accessible and editable, but the copyright notice will
appear to the user. Copying and exporting of user programs will be disabled. By
entering the password, the user can disable the copyright notice.
2. Protect Programming Source Code
This level will password-protect the contents of the Programming node in the project.
The programming contents can only be viewed or edited if the user enters the correct
password. The programming contents can be uploaded to an RMCTools project, but
cannot be viewed or edited unless the correct password is entered.
3. Copy Protection
In addition to password-protecting the programming, this level will prevent the
programming from being uploaded to an RMCTools project, thereby preventing the
project from being copied from one controller to another. Copy Protection also
298 Delta Computer Systems, Inc.