Delta RMC151 User Manual
Startup guide, Rmc150 motion controller
This manual is related to the following products:
Table of contents
Document Outline
- Where to Get Help
- Contents
- Step 1: Mounting
- Step 2: Wiring
- Step 3: Install RMCTools
- Step 4: Connect RMC to PC
- Step 5: Start a New Project
- Step 6: Define the Axes
- Step 7: Test an Actuator
- Step 8: Connect Feedback Device
- Step 9: Scale and Offset
- Step 10: Set the Output Polarity
- Step 11: Tuning
- Continuing the Motion Application
- Diagnostic Tools
- Appendix A: Wiring
- General Wiring Information
- Wiring Power
- Control Output for all Axis Modules
- MDT Module Start/Stop or PWM Transducer Wiring
- SSI Transducer Wiring
- Analog Voltage Transducer Wiring
- Potentiometer with Exciter Pin
- Analog 4-20 mA
- Quadrature Encoder Wiring
- Resolver Module Transducer Wiring
- Discrete Output Wiring
- Discrete Input Wiring
- Appendix B: Mounting Dimensions
- Appendix C: Agency Compliance