Delta RMC151 - Manual (Page 670)

RMC70/150 and RMCTools User Manual
State Description
Steady Off PROGRAM Mode or no power
Steady Green RUN Mode
Communication LEDs
These LEDS are located below the Controller LED on a white background. These LEDs do
not convey 10/100, FDX/HDX, or Collision information. The user will have to rely on their
switch's LEDs or the RMCTools Ethernet Statistics to view those Ethernet status items.
Link/Act LED
The Link/Act LED reflects the status of the physical Ethernet connection between the
RMC and the device on the other end of the Ethernet cable. If this LED is not on or is
not blinking when you expect it to be, see the Ethernet Link/Act LED topic for
troubleshooting information.
State
Description
Off The Ethernet link is down
Flashing Green The Ethernet link is up, with activity
Steady Green The Ethernet link is up, no activity
Net LED
State
Description
Steady Off No power, or no IP address configured.
Steady Red Duplicate IP Address detected.
Flashing Red IP address configured and in use, and a
controlling EtherNet/IP I/O connection has
timed out and not been re-established.
Flashing Green IP address configured and in use, no
EtherNet/IP or PROFINET connections are
currently established, and there is no timed-out
controlling EtherNet/IP I/O connection.
Steady Green IP address configured and in use, at least one
EtherNet/IP or PROFINET connection is
currently established, and there is no timed-out
controlling EtherNet/IP I/O connection.
Discrete I/O LEDs
State Description
Off No power or input/output is off.
On Input/output is on.
Startup LED Test
When the RMC150 powers up, the LEDs listed below goes through these states, with a
250 msec delay between each step:
CPU LED Run LED Net LED
Green Off Off
Red Off Off
Green Green Off
Green Red Off
Green Off Green
650 Delta Computer Systems, Inc.