Delta RMC151 - Manual (Page 234)

RMC70/150 and RMCTools User Manual
Note: It is possible to add more analog inputs on the RMC70 than can be assigned to axes.
However, it is still possible to view the voltage of the extra analog inputs using the Analog
Input Registers. Inputs that are unassigned to axes can have no status bits, error bits, scaling,
filtering, etc.
Change the Order of Axes
Note: Delta recommends defining the order of the axes at the beginning of the project. Once
the project is underway, changing the axis order can break any programming you have
already done.
To change the axis order, use the Move Up and Move Down buttons.
The axes will adhere to this order throughout the entire RMC. The Axis Tools and
Command Tool will display the axes in this order, and the register addresses and tag
names will be defined by this order.
Buttons
Button Description
New Add a new axis.
Change Change or view the definition of the selected axis.
Remove
Remove the selected axis.
Move Up Move the selected axis up one position in the list.
Move Down Move the selected axis down one position in the
list.
Rename Rename the selected axis.
OK Close the dialog and apply the changes to the
project. If you are online with the controller, the
changes will also be applied to the controller.
If you accessed this dialog from the New
Controller Wizard, the changes will be applied to
the wizard.
Cancel Close the dialog without applying any changes.
4.8. Command Tool
4.8.1. Command Tool
To access this tool:
If the Command Tool is not already open, on the View menu, click Command Tool, or press
Alt+8.
The Command Tool is dockable and can be resized and moved as desired.
Use the Command Tool to send commands to the RMC.
Tip:
To send commands to the RMC quickly, or to ease the process of issuing the same command
multiple times, use Shortcut Commands.
Sending Commands
214 Delta Computer Systems, Inc.