Delta RMC151 - Manual (Page 1084)

RMC70/150 and RMCTools User Manual
F21:2 10757 D10756 REAL %MD21.2 DINT Read Only RS-232 Monitor Protocol
F21:3 10759 D10758 REAL %MD21.3 DINT Read Only RS-232 Monitor Address
F21:4 10761 D10760 REAL %MD21.4 DINT Read Only PROFIBUS: Station Address
Indicates the current PROFIBUS station
address, as selected by the rotary
switches on the front of the RMC75P.
Possible values are from 0-99, although
zero (0) is not a valid station address.
F21:5 10763 D10762 - %MD21.5 - - Reserved
F21:6 10765 D10764 DWORD %MD21.6 DWORD Read Only PROFIBUS Connection Status
RMC70 Registers, File 22: Event Log Configuration
This file is used by RMCTools to configure Event Log filtering. It should not be edited directly.
Instead use the Event Log Properties to change these settings from within RMCTools.
RMC70 Registers, File 23: Discrete I/O
All Discrete I/O registers are Read/Write.
Tip:
For the DF1/CSP addressing format, all 'F' type registers (32-bit floating point) can also be
read as 'L' type (32-bit word) registers. This is very useful when reading registers with
DWORD or DINT external data types.
AB
DF1,CSP
Address
Modbus
TCP,RTU
Address
FINS
Address
External
Data
Type
Internal
IEC
Address
Internal
Data
Type Tag Name
Register
Name
F23:0 11777 D11776 DWORD %MD23.0 DWORD _DIO.State[0] Current
state of
discrete
I/O - bits
0-31
F23:1 11779 D11778 DWORD %MD23.1 DWORD _DIO.State[1] Current
state of
discrete
I/O - bits
32-64
F23:2 11781 D11780 DWORD %MD23.2 DWORD _DIO.Type[0] I/O Type -
bits 0-31
F23:3 11783 D11782 DWORD %MD23.3 DWORD _DIO.Type[1] I/O Type -
bits 32-64
F23:6 11789 D11788 DWORD %MD23.6 DWORD _DIO.OffInProgram[0] Output to
Off in
PROGRAM
mode -
bits 0-31
F23:7 11791 D11790 DWORD %MD23.7 DWORD _DIO.OffInProgram[1] Output to
Off in
PROGRAM
1064 Delta Computer Systems, Inc.