Delta RMC151 - Manual (Page 1022)

RMC70/150 and RMCTools User Manual
Description
This register specifies the rate at which the output is ramped to zero volts due to an Open
Loop Halt or Direct Output Halt. An Open Loop Halt can be initiated by the Open Loop
Halt (2) command or an Auto Stop. A Direct Output Halt can be initiated by the Direct
Output Halt (3) command or an Auto Stop.
9.2.3. Communication Registers
9.2.3.1. Ethernet Status
Type: Communications Register
RMC70 Address: %MD21.10. See Register Map topic for other address formats.
RMC150
Address:
%MD45.10. See Register Map topic for other address formats.
System Tag: _Enet.Status
How to Find: Address Selection Tool → Controller → Communication Settings →
Ethernet
Data Type: DWORD
Accessibility: Read Only
This register indicates the state of various Ethernet communication items.
Bit Tag Name
Description
0 _Enet.Status.LinkUp Link
True: The Ethernet link is up, and the Ethernet Link/Act LED
will be green (steady or flashing).
False: The Ethernet link is down.
1 _Enet.Status.100Mbps 100 Mbps
True: The Ethernet speed is 100Mbps
False: The Ethernet speed is 10Mbps
2 _Enet.Status.FullDuplex Full Duplex
True: The Ethernet is full-duplex.
False: The Ethernet is half-duplex.
4-7 _Enet.Status.IPState Current IP Address State
0: Static Method, but an unusable address is assigned (e.g.
0x00000000)
1: IP Address assigned and in use
2: IP Address assigned, but disabled due to duplicate detected
3: IP Address assigned, but still doing Address Collision
Detection
4: BOOTP: Still querying, no address yet assigned
5: DHCP: Still querying, no address yet assigned
9.2.3.2. Ethernet Configuration Bits
1002 Delta Computer Systems, Inc.