Delta RMC151 - Manual (Page 1153)

10 Wiring and Installation
10.2.6. MAx Wiring
The MAx module can be wired to MDT and SSI transducers. Each axis on the MAx also has a
Fault input, Enable output, and a Control output. If the MA module has two axes, each axis'
pinout is identical.
Use shielded twisted pairs for all connections to inputs and outputs. Route the transducer
wiring separate from other wiring. You must provide the power supplies needed by your
transducers. See Wiring Guidelines for general wiring information.
Wire clamp screws must be tightened to max 7 b-in (0.8Nm).
NOTE:
The following example schematics do not include transducer pin numbers, color codes, or
power supply requirements, since these vary between different transducers. To determine
your power supply needs and connector pin-outs or cable color codes, consult your transducer
manufacturer's documentation.
Pin-Out
Pin
# MA1 Label MA2 Label Function
1 +Fault In Flt In+ Fault Input
2 -Fault In Flt In-
3 +Enable Out En Out+ Enable Output
4 -Enable Out En Out-
5 Control Out Ctrl Out Control Output
6 Common Cmn Common
7 +Int/Clock Int/Clk+ MDT Interrogation or SSI Clock
8 -Int/Clock Int/Clk-
9 Common Cmn Common
10 +Ret/Data Ret/Dat+ MDT Return or SSI Data
deltamotion.com 1133