Delta RMC151 User Manual
Page 603
6 Communication
ii.
At the bottom of the Out – Produce tab, click New.
iii.
In the Edit Tag dialog box, enter the Omron source tag name in the Name
box, and enter the length of the RMC’s consumed data in bytes in the Size
box. This value must be four times the RMC’s 0006 Consumed Data Length
device parameter above. Notice that for Omron CS1 and CJ1 PLCs, the tag
name must be an Omron address. An address in the H memory range is
recommended to allow direct bit access.
iv.
Click OK.
v.
If prompted to add another tag, click Close.
The Out – Produce tab should now look like this:
deltamotion.com
583