Delta RMC151 - Manual (Page 1024)

RMC70/150 and RMCTools User Manual
How to Find: Address Selection Tool → Controller → Communication Settings →
Ethernet
Data Type: DWORD
Accessibility: Read Only
This register indicates the state of the Controlling Connection for EtherNet/IP I/O and
PROFINET communications. For more details, see Handling Broken EtherNet/IP I/O
Connections and Handling Broken PROFINET Connections.
Bit Tag Name
Description
0 _Enet.CCStatus.Active Controlling Connection Active
This bit is set as long as a Controlling Connection is currently
active. If the connection is closed or timed out, this bit will
be cleared.
1 _Enet.CCStatus.TimedOut Controlling Connection Timed Out
This bit is set when a Controlling Connection timed out.
Notice that this is only one method of a controlling
connection being closed (another example is the PLC
intentionally closing it). This bit is cleared when the
Controlling Connection is re-opened. The user can look for
the rising edge of this bit in the Program Triggers to respond
to a time-out.
A time-out can occur when the cable is disconnected, or
when the client is powered off or reset.
PROFINET controlling connections do not use this bit. Only
the Active bit can be used for PROFINET controlling
connections.
9.2.3.4. Controlling PLC Status
Type: Communications Register
RMC70 Address: %MD21.24. See Register Map topic for other address formats.
RMC150
Address:
%MD45.24. See Register Map topic for other address formats.
System Tag: _Enet.PLCStatus
How to Find: Address Selection Tool → Controller → Communication Settings →
Ethernet
Data Type: DINT
Accessibility: Read Only
This register indicates the state of the controlling PLC via EtherNet/IP I/O and PROFINET
communications. For more details, see Handling Broken EtherNet/IP I/O Connections and
Handling Broken PROFINET Connections.
This register (DINT data type) can hold one of three values:
0: Unknown (applies whenever no controlling connection is active)
1: Run
1004 Delta Computer Systems, Inc.