Renesas SH7781 - Manual (Page 316)

10. Interrupt Controller (INTC)
Rev.1.00 Jan. 10, 2008 Page 286 of 1658
REJ09B0261-0100
(6) Interrupt Mask Register 1 (INTMSK1)
INTMSK1 is a 32-bit readable and conditionally writable register that sets masking for IRL
interrupt requests. To clear the mask setting for the interrupt, write 1 to the corresponding bit in
INTMSKCLR1. Writing 0 to the bits in INTMSK1 has no effect. By reading this register once
after writing to this register or after clearing the mask by setting IMTMSKCLR1, the time length
necessary for reflecting the register value can be assured (the value read is reflected to the mask
status).
16 17 18 19 20 21 22 23 24 25 26 27 28 29 31 30
0 0 0 0 0 0 0 0 1 1 1 1 1 1 1 1
⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ IM10 IM11
R R R R R R R R R R R R R R R/W R/W
Bit:
Initial value:
R/W:
0 1 2 3 4 5 6 7 8 9 10 11 12 13 15 14
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯ ⎯
R R R R R R R R R R R R R R R R
Bit:
Initial value:
R/W:
Bit Name
Initial
Value R/W Description
31 IM10 1 R/W Mask setting for all
IRL3 to
IRL0 interrupt sources
when pins IRQ/
IRL3 to
IRQ/
IRL0 operate as an
encoded interrupt input.
30 IM11 1 R/W Mask setting for all
IRL7 to
IRL4 interrupt sources
when pins IRQ/
IRL7 to
IRQ/
IRL4 operate as an
encoded interrupt input.
[When read]
0: The interrupt is
accepted.
1: The interrupt is
masked.
[When written]
0: No effect
1: Masks the interrupt
29 to 24
⎯ All
1 R Reserved
These bits are always read as 1. The write value
should always be 1.
23 to 0
⎯ All
0 R Reserved
These bits are always read as 0. The write value
should always be 0.