Ssi scale/offset calibration utility, Quadrature calibration utility, 4 ssi scale/offset calibration utility – Delta RMC101 User Manual
Page 88: 5 quadrature calibration utility
RMC100 and RMCWin User Manual
3-38
• If you had the extend and retract limits set correctly, click Use current limits, adjusted for
new Scale and Offset
to adjust the limits for your new Scale and Offset.
• Otherwise, click Set limits to the following values and type the limits in the text boxes.
6. Click Apply, which sets the Scale, Offset, the Prescale Divisor bits of the Configuration word,
Extend Limit, and Retract Limit.
7. Click Done.
8. Issue a 'P' command for the axis to have the new parameters take affect.
3.4.20.4 SSI Scale/Offset Calibration Utility
For a description of all Scale/Offset Calibration Utilities, see Using the Scale/Offset Calibration
Utilities. To use the SSI Scale/Offset Calibration Utility:
1. Gather the following pieces of information for an axis:
• The desired number of position units per inch, millimeter, or centimeter
• The resolution of the transducer and its units (e.g. 0.005 mm)
• The transducer counts at your desired zero position
• Whether you wish to have your position units increase or decrease with increasing counts
2. Place the cursor in a field under the axis you wish to calibrate.
3. From the Tools menu, click SSI Scale/Offset Calibration.
4. Enter the above pieces of information.
5. Under Extend/Retract Limits, choose how you wish to have the limits set:
• If you had the extend and retract limits set correctly, click Use current limits, adjusted for
new Scale and Offset
to adjust the limits for your new Scale and Offset.
• Otherwise, click Enter limits above and type the limits in the text boxes.
6. Click Apply, which sets the Scale, Offset, the Prescale Divisor bits of the Configuration word,
Extend Limit, and Retract Limit.
7. Click Done.
8. Issue a 'P' command for the axis to have the new parameters take affect.
3.4.20.5 Quadrature Calibration Utility
For a list of all Scale/Offset Calibration Utilities, see Using the Scale/Offset Calibration Utilities. To
use the Quadrature Calibration Utility:
1. Gather the following pieces of information for an axis: