Read-back versus write mode, Read-back versus write mode -24, 4 read-back versus write mode – Delta RMC101 User Manual
Page 74
RMC100 and RMCWin User Manual
3-24
To select a single cell from the keyboard:
1. Use the arrow keys to highlight a different cell.
To select multiple cells:
1. Press and hold SHIFT at the first cell to be selected.
2. Use the arrow keys to change the last cell to be selected.
3. Release SHIFT.
Once one or more cells have been selected, type the desired value using one of the following
formats:
• To enter decimal numbers, type the value, without a leading zero.
• To enter hexadecimal numbers, type a leading 0x followed by the hexadecimal digits. For
example, 0xFFE0. Notice that for backward compatibility, hexadecimal values may be entered
with only a leading 0. However, they will always be displayed with the 0x.
• To enter an ASCII command, type the letter of the command. Notice that this works only in the
COMMAND field. For example, W.
Press ENTER to finalize your changes, or ESC or cancel your edits.
Note:
In the fields that display values in hexadecimal, Pop-up Editors can be used to edit the
data. This is the easiest way to ensure that these words are modified correctly.
Commands can also be issued using shortcut keys. To learn the command shortcut keys, click
the Command menu, and look at the right column of the menu. For example, ALT+P will issue
the P - Set Parameters command. Commands can also be issued using Stored Commands; see
Using Stored Commands for more information.
Data may also be copied around the main screen. The keys used for doing so are identical to
most spreadsheets.
• To cut cells to the clipboard, press CTRL+X.
This combination is available in the table editors, but not in the main window.
• To copy cells to the clipboard, press CTRL+C.
• To paste from the clipboard to the current location, press CTRL+V. When pasting a group of cells
at once, the destination cells should not be selected. Instead, the cursor should be placed in the
upper-leftmost cell to which you want the block to be copied.
3.4.4 Read-back versus Write Mode
The Command and Parameter areas of the main screen can operate in either of the following two
modes: