Delta RMC101 - Manual (Page 519)

RMC CPU RS232 Port 5.6
Communications 5-269
• Any other cable you have will work if you can verify that pins 2, 3, and 5 on the RMC-end of the
cable are connected as shown in the above diagram. An Ohmmeter or continuity checker will
work for verifying the cable connections.
Cable Recommendations for Female DB9 Connector (older)
The recommendations for the older female DB9 connector are the same as for the male DB9
connector, but the gender on the RMC-end of the cable must be reversed:
• Generic null-modem (female on both ends) serial cable with a 9-pin female-to-male gender
changer
• Allen-Bradley PLC Serial Cable with a 9-pin female-to-male gender changer
• Modicon Modbus cable
• Siemens SIMATIC 505 Programmable Controller Serial Cable with a 9-pin female-to-male gender
changer
• You can build an RS232 cable using the diagram above, except the gender of the RMC-end
connector should be reversed.
• Any other cable you have will work if you can verify that pins 2, 3, and 5 on the RMC-end of the
cable are connected as shown in the above diagram. An Ohmmeter or continuity checker will
work for verifying the cable connections.