Delta RMC101 - Manual (Page 523)

LCD420 Terminal 5.7
Communications 5-273
Next, enter the value of 4.8 in/s. Notice that the cursor moves to the end of the field during the edit.
Press 4:
Press 8:
Notice that pressing ENTER at this point would enter a value of 0.048 in/s and not the desired 4.8
in/s, so you must pad the number of zeros. Press 0:
Press 0:
Now, press ENTER to accept the edit:
The cursor moves to the start of the field to indicate that the edit is complete.
Editing a Bit Field
First, select the screen and field you wish to edit as described above. Then press 1 to turn the bit
on or 0 to turn the bit off, and press ENTER. While editing, the cursor moves to the last character
in the field. This indicates that the new value has not been accepted yet. ENTER must be
pressed to have the new value take effect.
The following table summarizes the keys used for editing:
Press To
0 Set the bit's value to OFF.