7 position-pressure example (part 5), Position-pressure example (part 5) -56 – Delta RMC101 User Manual
Page 242
RMC100 and RMCWin User Manual
4-56
4.12.7 Position-Pressure Example (Part 5)
This is Part 5 of the complete step-by-step example of setting up and tuning a position/pressure
axis.
Part 5: Tuning the position-to-pressure transition.
Now that the position has been tuned and the pressure has been tuned, we can focus on the
transition from position to pressure.
• Run Event Step 1 again. It looks like this:
o
The pressure lags after pressure control begins.
o
Add Feed Forward to keep pressure from lagging. In this case, the Feed Forwards were set
to 13:
This manual is related to the following products: