Delta RMC101 - Manual (Page 155)

Curve Tool 3.9
Using RMCWin 3-105
The Insertion Point is indicated by an "asterisk" (
) in the header for that point.
See Also: Curve Tool Topics
3.9.5.8 Curve Tool: Resizing columns
The columns in the spreadsheet can be resized to increase or decrease the width of the column.
When the Spreadsheet is displayed vertically along the right or left side of the curve tool, the
columns in the spreadsheet can be resized individually. That is, each column can have a different
size.
When the Spreadsheet is displayed horizontally along the bottom or top of the curve tool, the
columns in the spreadsheet must all be the same size. That is, resizing one column will cause all
the columns to be resized to the same width.
To change a column's width:
1. On the Tools menu, click Options.
2. In the Options dialog box, click the Spreadsheet tab.
3. Type new widths for the column(s) to be changed in inches, or click Set All To Default, to restore
the column widths to the default settings.
4. Click OK to apply the new settings.
If the value specified is smaller than the minimum column width allowed, an error message will be
displayed and the column width will be set to the minimum value.
To Change a column's width using the mouse:
1. Move the pointer over the right edge of the cell whose width you want to change.
2. When the pointer becomes a , drag the cell divider left or right to decrease or increase the
column's width.
See Also: Curve Tool Topics
3.9.6 Using Curves
3.9.6.1 Curve Tool: Selecting Which Curves to Display
All axes in an RMC can have curves associated with them except for auxiliary pressure axes.
However, because it can be confusing to display multiple curves simultaneously, you can control
which axes are displayed in the Graph view.
You can view or change which axis curves are displayed using either the toolbar or the menu.