Delta RMC101 User Manual
Page 184
RMC100 and RMCWin User Manual
3-134
ensure that the program starts with the correct settings. Notice that most users will have no need
for these options because they are saved from one execution of RMCWin to another. Options
given on the command-line override the previously saved settings.
The following options are available:
-1, -2,
-3, -4
Select COM1, COM2, COM3 or COM4 as the serial port to use. This will
override any communication path setting for the current board file.
-Dn
Generate a debug log file named Debug.txt in the current directory. The
logging level is controlled by n, which can be from 0 (no logging) to 5 (most
logging). There is no logging enabled by default.
-F
Force initialization onto module. See Forcing Initialization for details.
-L
Start in Look-only mode. See Using Look-only Mode for details.
-M
Allow multiple instances of RMCWin to run at once with the same board file
open. The copy of RMCWin that is started with this command and all
subsequent RMCWin instances started can run at the same time. This will
continue until the Limit Instances to One per Board File check box on the
Preferences tab of the Options dialog box is set.
-P
Start RMCWin with the communication path closed. This can be used for
demonstrations or offline editing.
-R
Start in Read-back mode. See Read-back versus Write Mode for details.
-W
Start in Write mode. See Read-back versus Write Mode for details.
Board
file
The parameter after the filename that does not start with a ’r;-’ or ’r;/’ gives
the board filename that is used on startup (e.g. rmcwin carriage.bd1). See
Using Multiple Motion Modules for details on board files.