NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 98)

4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select System > Management > Time > NTP Server Configuration.
The NTP Server Configuration page displays.
6. From the Server Type menu, select the type of NTP address to enter in the address
field.
The address can be an IPv4 address, IPv6 address, or host name (DNS). The default
is DNS.
7. In the Address field, specify the IP address or the host name of the NTP server.
This is an IP address or a text string of up to 64 characters, containing the encoded
unicast IP address or host name of an NTP server. Unicast NTP requests are sent to
this address. If this address is a DNS host name, the host name is resolved into an
IP address each time an NTP request is sent to it.
8. In the Version field, specify the NTP version that is supported by the switch.
The range is from 1 to 4. The default is 4.
9. In the Key ID field, specify the authentication key number that the switch uses to
communicate with the NTP server.
The range is from 0 to 4294967295.
10. In the Minimum Poll Interval field, specify the shortest polling interval in powers
of two seconds.
The range is from 4 to 17. The default is 6.
11. In the Minimum Poll Interval field, specify the longest polling interval in powers of
two seconds.
The range is from 4 to 17. The default is 10.
12. From the Prefer menu, select Yes to assign the NTP server as the preferred NTP
server.
A preferred server reduces the number of times that the switch must change between
different NTP servers. The default is No, which means that an NTP server is not a
preferred server.
13. From the Burst menu, select Yes to let the switch send a series of packets instead
of a single packet within each synchronization interval.
If you select No, a single packet is sent, which might cause slower synchronization.
The default is Yes.
Main User Manual 98 Configure Switch System
Information
Fully Managed Switches M4350 Series Main User Manual