beautypg.com

NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual

Page 866

background image

The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.

The System Information page displays.

5. Select Monitoring > Mirroring > RSPAN Source Switch Configuration.

The RSPAN Source Switch Configuration page displays.

6. From the Session ID menu, select 1, 2, 3, or 4 as the RSPAN source switch session

ID.

You can set up four RSPAN source switch configurations that functions independently
from each other.

7. Enable or disable the RSPAN source switch configuration by selecting one of the

following Admin Mode radio buttons:

True: The selected source interfaces are mirrored. That is, traffic entering or
leaving the source interfaces is copied (mirrored) to the selected RSPAN
destination VLAN.

False: The selected source interfaces are not mirrored.

8. From the RSPAN Destination VLAN menu, select the destination VLAN to which

traffic must be copied.

For each RSPAN source switch configuration, you can configure one RSPAN
destination VLAN port only. The default is None.

9. From the RSPAN Reflector Port menu, select the interface that is connected to the

RSPAN destination switch.

10. From the Filter Type menu, select if traffic must be filtered:

None: All traffic is sent to the destination VLAN.

IP ACL: Traffic is filtered according to the IP ACL for which you must type the
name in the Filter Name field. Only traffic that matches the rules in the IP ACL is
sent to the destination VLAN.

For more information about IP ACLs, see Configure a basic or extended IPv4 ACL
on page 804.

MAC ACL: Traffic is filtered according to the MAC ACL for which you must type
the name in the Filter Name field. Only traffic that matches the rules in the MAC
ACL is sent to the destination VLAN.

For more information about MAC ACLs, see Configure a MAC ACL on page 794.

The following steps refer to the RSPAN Source Interface Configuration section, in
which you must select one or more source interfaces and set the traffic direction.

11. Select whether to display physical interfaces, LAGs, the CPU, VLANs, or all by clicking

one of the following links above the table heading:

1 or Unit ID for a stacked switch:

Main User Manual

866

Monitor the Switch and Network

Fully Managed Switches M4350 Series Main User Manual