NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 614)

- Send: Packets are forwarded unmodified. This is the default confirming
action.
- Drop: Packets are dropped.
- Mark CoS: Packets are marked by DiffServ with the specified CoS value
before being forwarded. This selection requires that the Mark CoS field is
set. You must select a CoS value from 0 to 7 from the menu.
- Mark IP Precedence: These packets are marked by DiffServ with the
specified IP Precedence value before being forwarded. This selection
requires that the Mark IP Precedence field is set. You must select an IP
precedence value from 0 to 7 from the menu.
- Mark IP DSCP: Packets are marked by DiffServ with the specified DSCP
value before being forwarded. This selection requires that the DSCP field
is set. You must either select a DSCP code from the menu or enter an IP
DSCP value from 0 to 63 in the field next to the menu. A value that you
enter in the field overrides any selection from the menu. The DSCP value
is defined as the high-order six bits of the Service Type octet in the IP
header.
c. Specify a policy action for packets that violate the simple policy.
- Send: Packets are forwarded unmodified. This is the default violating
action.
- Drop: Packets are dropped.
- Mark CoS: Packets are marked by DiffServ with the specified CoS value
before being forwarded. This selection requires that the Mark CoS field is
set. You must select a CoS value from 0 to 7 from the menu.
- Mark IP Precedence: These packets are marked by DiffServ with the
specified IP Precedence value before being forwarded. This selection
requires that the Mark IP Precedence field is set. You must select an IP
precedence value from 0 to 7 from the menu.
- Mark IP DSCP: Packets are marked by DiffServ with the specified DSCP
value before being forwarded. This selection requires that the DSCP field
is set. You must either select a DSCP code from the menu or enter an IP
DSCP value from 0 to 63 in the field next to the menu. A value that you
enter in the field overrides any selection from the menu. The DSCP value
is defined as the high-order six bits of the Service Type octet in the IP
header.
• Two Rate: Select this radio button to define a two-rate traffic policing style for
the class. A two-rate policy differs from a simple policy in that the two-rate policy
allows you to define a peak rate and a peak burst size, in addition to the committed
rate and committed burst size.
Main User Manual 614 Configure Quality of Service
Fully Managed Switches M4350 Series Main User Manual