NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 711)

Add a private port group
After you add a private group, you can add members to the group (see Configure the
membership of a private port group on page 712).
To add a private port group:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Security > Traffic Control > Private Group > Private Group Configuration.
The Private Group Configuration page displays.
6. In the Group Name field, enter the private group name.
The name can be up to 24 characters.
7. From the Group Mode menu, select the mode for the private group:
• Isolated: A port that you add as member of the group cannot forward its egress
traffic to any other members in the same group.
• Community: A port that you add as member of the group can forward its egress
traffic to other members in the same group, but not to members in other groups.
8. Click the Add button.
The private group is added.
9. To save the settings to the running configuration, click the Save icon.
Remove a private port group
You can remove a private port group that you no longer need.
Main User Manual 711 Manage Switch Security
Fully Managed Switches M4350 Series Main User Manual