NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 568)

The BSR Candidate Configuration page displays.
6. From the Interface menu, select the interface.
7. Click the Delete button.
Your settings are saved. The PIM BSR candidate configuration is deleted from the
interface.
8. To save the settings to the running configuration, click the Save icon.
Configure a static IPv6 PIM rendezvous point
for a group
You can add a new or change an existing static IPv6 PIM rendezvous point (RP) for a
group.
To add or change a static IPv6 PIM RP for a group:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > IPv6 Multicast > IPv6 PIM > Static RP Configuration.
The Static RP Configuration page displays.
6. If you are changing an existing static RP, select the check box for the static RP.
7. In the RP Address field, specify the IPv6 address for the static RP.
8. In the Group Address field, specify the IPv6 address for the group to which the static
RP applies.
9. In the Prefix Length field, specify the IPv6 prefix length for the group to which the
static RP applies.
10. From the Override menu, select Enable or Disable to enable or disable the override
capacity of a static RP over an RP that is learned from a BSR.
Main User Manual 568 Configure Multicast Routing
Fully Managed Switches M4350 Series Main User Manual