NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 165)

If no switch stack is configured, the only option is unit ID 1.
• All: The physical interfaces for all switches in the stack are displayed.
If no switch stack is configured, the All option does not have any effect.
7. Select one or more interfaces by taking one of the following actions:
• To configure a single interface, select the check box associated with the interface,
or type the interface number in the Go To Interface field and click the Go button.
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the
heading row.
8. From the Admin mode menu, select to enable or disable the DHCPv6 relay mode
on the interface.
NOTE: DHCPv6 relay and DHCPv6 server functions are mutually exclusive.
For information about configuring an interface as a DHCPv6 server, see
Configure the DHCPv6 settings for an interface on page 158.
9. From the Relay Interface menu, select the interface, LAG, or VLAN that is connected
to the DHCPv6 relay server.
10. In the Destination IP Address field, specify the IPv6 address for the DHCPv6 relay
server.
11. In the Remote ID field, specify the relay agent information option.
The remote ID is derived from the DHCPv6 server DUID and the relay interface
number, or you can specify is as a user-defined string.
12. Click the Apply button.
Your settings are saved.
13. To save the settings to the running configuration, click the Save icon.
Power over Ethernet
You can configure the global Power over Ethernet (PoE) configuration settings and the
PoE settings for each port.
Main User Manual 165 Configure Switch System
Information
Fully Managed Switches M4350 Series Main User Manual