NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 471
-
1: If no switch stack is configured, the physical interfaces for the switch are
displayed.
-
Unit ID for a stacked switch: If a switch stack is configured, the physical
interfaces for the switch with the selected stack unit ID are displayed.
•
VLANS: Only VLANs are displayed.
•
All: Both physical interfaces and VLANs are displayed, or for a switch stack, both
physical interfaces on all switches and VLANs are displayed.
7. Select one or more interfaces or VLANs by taking one of the following actions:
•
To configure a single interface or VLAN, select the check box associated with the
interface or VLAN, or type the interface or VLAN number in the Go To Interface
field and click the Go button.
•
To configure multiple interfaces or VLANs with the same settings, select the check
box associated with each interface or VLAN.
8. In the Area ID field, enter an OSPF area ID.
An area ID is a 32-bit integer in dotted-decimal format that identifies the area to
which a switch interface connects.
9. Select an Admin Mode radio button:
•
Enable: OSPF is enabled for the interface.
•
Disable: OSPF is disabled for the interface. This is the default setting.
OSPF can become operational on the interface only if the interface is configured
with an IP address and subnet mask (see Configure IPv4 routing interfaces on page
403).
You can configure the OSPF settings without enabling OSPF on the interface, but
the change does not take effect until you enable OSPF on the interface. The following
fields display only if you enable OSPF on the interface:
State, Designated Router, Backup Designated Router, Number of Link Events, Local
Link LSAs, and Local Link LSA Checksum.
10. In the Router Priority field, enter the OSPF priority for the interface.
This is a number from 0 to 255. The default is 1, which is the highest router priority.
A value of 0 indicates that the router is not eligible to become the designated router
on this network.
11. In the Retransmit Interval field, enter the number of seconds between link-state
advertisements for adjacencies, that is, for neighboring devices that form an OSPF
adjacency with the interface.
The interval is also used when retransmitting database descriptions and link-state
request packets. The value for the interval ranges from 1 to 3600 seconds (1 hour).
The default is 5 seconds.
12. In the Hello Interval field, enter the OSPF hello interval for the interface.
Main User Manual
471
Configure OSPF and OSPFv3
Fully Managed Switches M4350 Series Main User Manual