NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 790)

• ACL Based on Destination IPv6 L4 Port: Creates an ACL based on the
destination IPv6 Layer 4 port number.
• ACL Based on Source IPv6 L4 Port: Creates an ACL based on the source IPv6
Layer 4 port number.
NOTE: For L4 port options, two rules are created (one for TCP and one for
UDP).
7. In the Sequence Number field, enter a whole number in the range from 1 to
2147483647 that is used to identify the rule.
8. From the Action menu, select Permit or Deny to specify the action that must be
taken if a packet matches the rule’s criteria.
9. From the Match Every menu, select one of the following options:
• False: Packets do not need to match the selected ACL and rule. With this selection,
you can add a destination MAC address, destination MAC mask, and VLAN.
• True: All packets must match the selected ACL and rule and are either permitted
or denied. In this case, since all packets match the rule, the option of configuring
other match criteria is not offered.
10. Specify the additional match criteria for the selected ACL type.
The rest of the rule match criteria fields available for configuration depend on the
selected ACL type. For information about the possible match criteria fields, see the
following table.
Fields ACL Based On
• Destination MAC: Specify the destination MAC address to compare against
an Ethernet frame. The format is xx:xx:xx:xx:xx:xx. The BPDU keyword might
be specified using a destination MAC address of 01:80:C2:xx:xx:xx.
• Destination MAC Mask: Specify the destination MAC address mask, which
represents the bits in the destination MAC address to compare against an
Ethernet frame. The format is xx:xx:xx:xx:xx:xx. The BPDU keyword might
be specified using a destination MAC mask of 00:00:00:ff:ff:ff.
• VLAN: Specify the VLAN ID to match within the Ethernet frame.
Destination MAC
• Source MAC: Specify the source MAC address to compare against an
Ethernet frame. The format is xx:xx:xx:xx:xx:xx.
• Source MAC Mask: Specify the source MAC address mask, which represents
the bits in the source MAC address to compare against an Ethernet frame.
The format is (xx:xx:xx:xx:xx:xx).
• VLAN: Specify the VLAN ID to match within the Ethernet frame.
Source MAC
• Destination IP Address: Specify the destination IP address.
• Destination IP Mask: Specify the destination IP address mask.
Destination IPv4
Main User Manual 790 Manage Switch Security
Fully Managed Switches M4350 Series Main User Manual