beautypg.com

NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual

Page 525

background image

-

1: If no switch stack is configured, the physical interfaces for the switch are
displayed.

-

Unit ID for a stacked switch: If a switch stack is configured, the physical
interfaces for the switch with the selected stack unit ID are displayed.

VLANS: Only VLANs are displayed.

All: Both physical interfaces and VLANs are displayed, or for a switch stack, both
physical interfaces on all switches and VLANs are displayed.

7. Select one or more interfaces or VLANs by taking one of the following actions:

To configure a single interface or VLAN, select the check box associated with the
interface or VLAN, or type the interface or VLAN number in the Go To Interface
field and click the Go button.

To configure multiple interfaces or VLANs with the same settings, select the check
box associated with each interface or VLAN.

8. From the Interface Mode menu, select if DVMRP is enabled on the interface:

Enable: DVMRP is enabled for the interface.

Disable: DVMRP is disabled for the interface. This is the default setting.

9. In the Interface Metric field, enter the DVMRP metric for the interface.

The interface sends the metric in DVMRP messages that state the route cost to reach
the switch. The range is from 1 to 31. The default is 1.

10. Click the Apply button.

Your settings are saved.

11. To save the settings to the running configuration, click the Save icon.

The following table describes the view-only fields on the page.

Description

Field

The operational state of the DVMRP protocol on the interface: Operational or
Non-Operational.

Protocol State

The IP address that is used as a source address in packets sent from the interface.

Local Address

The DVMRP generation ID used by the switch for the interface.

This ID is reset each time the interface is started and is sent in prune messages. A
change in generation ID informs the neighbor routers to discard any previous
information about the switch.

Generation ID

The number of invalid packets received on the interface.

Received Bad Packets

The number of invalid routes received on the interface.

Received Bad Routes

The number of routes sent on the interface.

Sent Routes

Main User Manual

525

Configure Multicast Routing

Fully Managed Switches M4350 Series Main User Manual