NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 308)

To configure IGMP snooping automatically:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching > Multicast > IGMP Snooping > Configuration.
The Configuration page displays.
6. Select the IGMP Plus Mode Enable or Disable radio button.
If enabled, the following IGMP snooping modes are automatically enabled:
• Admin mode
• Proxy Querier mode
• Report Flood Mode
• Exclude Mrouter Interface Mode
• Fast Leave Auto-assignment Mode
The default is Enable.
If disabled, these IGMP snooping modes are automatically disabled.
NOTE: For information about other settings on the page, see Configure
IGMP snooping manually on page 309.
7. Click the Apply button.
Your settings are saved.
8. To save the settings to the running configuration, click the Save icon.
9. To refresh the page, click the Refresh button.
The following table describes the view-only fields on the page.
Main User Manual 308 Configure Switching Information
Fully Managed Switches M4350 Series Main User Manual