NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 816)

- The destination IP TCP port protocols are Domain, Echo, FTP, FTP data,
www-http, SMTP, Telnet, POP2, POP3, and BGP.
- The destination IP UDP port protocols are Domain, Echo, SNMP, NTP,
RIP, Time, Who, and TFTP.
Each of these values translates into its equivalent port number, which is used
as both the start and end of the port range.
Select Other from the menu to enter a port number. If you select Other from
the menu but leave the field blank, it means any.
The relevant matching conditions for L4 port numbers are as follows:
- Equal: The IP ACL rule matches if the Layer 4 source port number is equal
to the specified port number or port key.
- Not Equal: The IP ACL rule matches if the Layer 4 source port number is
not equal to the specified port number or port key.
- Less Than: The IP ACL rule matches if the Layer 4 source port number is
a lower number than the specified port number or port key.
- Greater Than: The IP ACL rule matches if the Layer 4 source port number
is a higher number than the specified port number or port key.
- Range: If you select the Range radio button, the IP ACL rule matches only if
the Layer 4 destination port number is within the specified port range. The
starting port, ending port, and all ports in between are a part of the Layer 4
port range.
The Start Port and End Port fields identify the first and last ports that are part
of the port range. They values can range from 0 to 65535.
You can either select the enter the port range yourself or select one of the
following protocols from the menu:
- The destination IP TCP port protocols are Domain, Echo, FTP, FTP data,
www-http, SMTP, Telnet, POP2, POP3, and BGP.
- The destination IP UDP port protocols are Domain, Echo, SNMP, NTP,
RIP, Time, Who, and TFTP.
Each of these values translates into its equivalent port number, which is used
as both the start and end of the port range.
Select Other from the menu to enter a port number. If you select Other from
the menu but leave the field blank, it means any.
The wildcard mask determines which bits are used and which bits are ignored.
A wildcard mask of 0.0.0.0 indicates that none of the bits are important. A
wildcard of 255.255.255.255 indicates that all of the bits are important.
Main User Manual 816 Manage Switch Security
Fully Managed Switches M4350 Series Main User Manual