NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 501)

11. In the Retransmit Interval field, enter the number of seconds between link-state
advertisements for adjacencies, that is, for neighboring devices that form an OSPFv3
adjacency with the interface.
The interval is also used when retransmitting database descriptions and link-state
request packets. The value for the interval ranges from 1 to 3600 seconds (1 hour).
The default is 5 seconds.
12. In the Hello Interval field, enter the OSPFv3 hello interval for the interface.
This interval must be the same for all routers and switches in the network. The interval
ranges from 1 to 65,535 seconds. The default is 10 seconds.
13. In the Dead Interval field, enter the number of seconds that the interface waits for
a neighbor’s hello packets before determining that the neighbor is down.
This interval must be the same for all routers and switches in the network. This interval
must be a multiple of the hello interval. The interval ranges from 1 to 65,535. The
default is 40 seconds. (The default hello interval is 10 seconds.)
14. In the Iftransit Delay Interval field, enter the estimated number of seconds required
to transmit a link state update packet over the interface.
The interval range from 1 to 3600 seconds (1 hour). The default is 1 second.
15. From the In the MTU Ignore menu, select if OSPFv3 MTU mismatch detection is
disabled:
• Enable: OSPFv3 MTU mismatch detection is disabled on incoming database
description packets. The default value is Disable (MTU mismatch detection is
enabled).
• Disable: OSPFv3 MTU mismatch detection is enabled on incoming database
description packets. This is the default setting.
16. From the Passive Mode menu, select if the interface does not form an adjacency:
• Enable: The interface is passive to prevent OSPFv3 from forming an adjacency.
OSPFv3 advertises networks attached to passive interfaces as stub networks.
• Disable: The interface is not passive and OSPFv3 can form an adjacency. This is
the default setting.
17. From the Network Type menu, select the type of OSPFv3 network for the interface:
• Broadcast: The interface can connect to multiple OSPFv3 routers. This is the
default setting.
• Point to point: The interface can connect to one other OSPFv3 router.
18. In the Metric Cost field, enter the value that OSPFv3 uses to compute the shortest
paths.
The range is from 1 to 65,535. The default is 1.
19. Click the Apply button.
Main User Manual 501 Configure OSPF and OSPFv3
Fully Managed Switches M4350 Series Main User Manual