beautypg.com

NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual

Page 463

background image

can be from –1 to 2147483647. The default setting is –1, which indicates that there
is no limit.

15. In the Default Metric field, set the default for the metric of redistributed routes.

The range is 1 from 16777214. The default is 0.

16. In the Maximum Paths field, set the number of paths that OSPF can report for a

destination.

The range is from 1 to 16. The default is 4.

17. In the AutoCost Reference Bandwidth field, set the bandwidth that controls how

OSPF calculates link cost.

Set the reference bandwidth in megabits per second. Unless a link cost is configured,
the link cost is computed by dividing the reference bandwidth by the interface
bandwidth. The range is from 1 to 4294967. The default is 100.

18. From the Default Passive Setting menu, select how the global passive mode setting

for all OSPF interfaces is configured:

Enable: Enabling the passive mode globally overwrites any passive mode setting
at the interface level. OSPF does not form adjacencies on passive interfaces, but
does advertise attached networks as stub networks.

Disable: The default is Disabled.

19. Click the Apply button.

Your settings are saved.

20. To save the settings to the running configuration, click the Save icon.

The following table describes the view-only fields on the page.

Description

Field

The router is an autonomous system boundary router (ASBR) if it is configured to
redistribute routes from another protocol, or if it is configured to originate an external
LSA advertising the default route.

ASBR Mode

The router is an area border router (ABR) if it has active non-virtual interfaces in two
or more OSPF areas.

ABR Status

The number of external (LS type 5) link state advertisements (LSAs) in the link state
database.

External LSA Count

The sum of the LS checksums of the external LSAs that are contained in the link state
database. You can use this sum to determine if there was a change in the link state
database of a switch or router, and to compare the link state databases of two devices.
This value is in hexadecimal.

External LSA
Checksum

The number of opaque LSAs with domain-wide flooding scope.

AS_OPAQUE LSA
Count

Main User Manual

463

Configure OSPF and OSPFv3

Fully Managed Switches M4350 Series Main User Manual