beautypg.com

NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual

Page 246

background image

To add a protocol-based VLAN group:

1. Launch a web browser.

2. In the address field of your web browser, enter the IP address of the switch.

If you do not know the IP address of the switch, see Log in to the main UI with a web
browser
on page 27 and the subsections.

The login page displays.

3. Click the Main UI Login button.

The main UI login page displays in a new tab.

4. Enter admin as the user name, enter your local device password, and click the Login

button.

The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.

The System Information page displays.

5. Select Switching > VLAN > Advanced > Protocol Based VLAN Group

Configuration.

The Protocol Based VLAN Group Configuration page displays.

6. In the Group ID field, specify a numerical ID.

You can enter an ID in the range from 1 to 128.

7. In the Group Name field, specify a name for the new group.

You can enter up to 16 characters.

8. In the Protocol field, specify one or more of the following protocols to be associated

with the group:

IP: IP is a network layer protocol that provides a connectionless service for the
delivery of data.

ARP: Address Resolution Protocol (ARP) is a low-level protocol that dynamically
maps network layer addresses to physical medium access control (MAC)
addresses.

IPX: The internetwork packet exchange (IPX) is a connectionless datagram
network-layer protocol that forwards data over a network.

Separate protocols by a comma (,). For example, to specify all three protocols, enter
the following: ip,arp,ipx

You can also enter hexadecimal or decimal values in the range of 0x0600(1536) to
0xFFFF(65535).

9. In the VLAN ID field, specify the VLAN ID.

Main User Manual

246

Configure Switching Information

Fully Managed Switches M4350 Series Main User Manual