NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 548)

4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > Multicast > PIM > Candidate RP Configuration.
The Candidate RP Configuration page displays.
6. From the Interface menu, select the interface.
7. In the Group Address field, specify the group IPv4 address that is transmitted in
candidate-RP-advertisements.
8. In the Group Mask field, enter the group address mask that is transmitted in
candidate-RP-advertisements.
9. In the C-RP Advertisement Interval field, specify the period in seconds at which
candidate-RP-advertisements are sent as unicast traffic to the bootstrap router (BSR).
The range is from 1 to 16383 seconds.
10. Click the Add button.
Your settings are saved. The PIM candidate RP is added.
11. To save the settings to the running configuration, click the Save icon.
Delete an IPv4 PIM candidate rendezvous
point configuration
You can delete an IPv4 PIM candidate rendezvous point (RP) configuration that you no
longer need.
To delete an IPv4 PIM candidate RP configuration:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
Main User Manual 548 Configure Multicast Routing
Fully Managed Switches M4350 Series Main User Manual