NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 448)

5. Select Routing > VRRP > Advanced > VRRP Configuration.
The VRRP Configuration page displays. The page shows different sections.
6. Select an Admin Mode radio button:
• Enable: VRRP is enabled for the switch.
• Disable: VRRP is disabled for the switch. This is the default setting.
7. Click the Apply button.
Your settings are saved.
8. To save the settings to the running configuration, click the Save icon.
9. In the VRID field, enter a number in the range from 1 to 255.
The VRID enables virtual routers to communicate with each other in a VRRP
configuration. That is, the primary and secondary virtual routers must have the same
VRID.
10. From the Interface menu, select the interface that must function as the primary virtual
router.
11. From the Pre-empt Mode menu, select if a backup virtual router can preempt the
primary virtual router:
• Enable: A backup VRRP router can preempt the primary virtual router if the
backup router has a greater priority than the primary virtual router
and the IP
address in the Primary IP Address field (see below) is not the IP address of the
primary virtual router. The default is Enable.
• Disable: A backup virtual router cannot preempt the primary virtual router.
12. From the Accept Mode menu, select if the primary virtual router can accept data
packets:
• Enable: The primary virtual router accepts all types of data packets that are
addressed to the IP addresses that is associated with the primary virtual router.
• Disable: The primary virtual router discards all types of data packets that are
addressed to the IP address that is associated with the primary virtual router,
unless the IP address in the Primary IP Address field (see below)
is the IP address
of the primary virtual router. The default is Disable.
13. In the Configured Priority field, enter the priority number that VRRP uses in the
election of the primary virtual router.
The range is from 1 to 254. If the virtual IP address is the same as the interface IP
address, the priority is always set to 254.
14. In the Advertisement Interval field, enter the time, in seconds, between the
transmission of advertisement packets by the router.
Enter a number from 1 to 255. The default value is 1 second.
15. In the Primary IP Address field, enter the IP address for the primary virtual router.
Main User Manual 448 Manage Routing
Fully Managed Switches M4350 Series Main User Manual