Dhcpv6 server, Enable the dhcpv6 server – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 152
The UDP interface is removed.
8. To save the settings to the running configuration, click the Save icon.
DHCPv6 server
You can configure settings for a DHCPv6 server, DHCPv6 pools, DHCPv6 prefix
delegation, DHCPv6 interfaces. and DHCPv6 bindings. You can also view DHCPv6
statistics.
Enable the DHCPv6 server
By default, the DHCPv6 server is disabled. You can enable it so that the switch can assign
network configuration information to IPv6 clients.
To enable the DHCPv6 server on the switch:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select System > Services > DHCPv6 Server > DHCPv6 Server Configuration.
The DHCPv6 Server Configuration page displays.
6. Select the Admin mode Enable radio button.
The default value is Disable.
7. Click the Apply button.
Your settings are saved.
Main User Manual
152
Configure Switch System
Information
Fully Managed Switches M4350 Series Main User Manual