beautypg.com

NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual

Page 874

background image

7. Use one of the following methods to select an interface for the flow poller and

sampler:

In the Go To Interface field, enter the interface in the unit/slot/port format and
click on the Go button.

Next to the Interface column, select the check box for the interface that you want
to use.

You can select physical ports only.

8. In the Poller Receiver Index field, specify the sFlow receiver that must be associated

with the poller.

For information about sFlow receivers, see Configure an sFlow receiver on page 871.

9. In the Poller Interval field, specify the number of seconds between successive

polling.

A sampling interval of 0 disables sampling. The range is from 0 to 86400 seconds.
The default is 0 seconds.

10. In the Sampler Receiver Index field, specify the sFlow receiver that must be

associated with the sampler.

For information about sFlow receivers, see Configure an sFlow receiver on page 871.

11. In the Sampling Rate field, specify the statistical sampling rate for packet sampling.

A sampling rate of 1 counts all packets. A sampling rate of 0 disables sampling. The
allowed range is 1024 to 65536. The default is 0.

12. In the Maximum Header Size field, specify the maximum number of bytes to be

copied from a sampled packet.

The range is from 20 to 256 bytes. The default is 128 bytes.

13. Click the Apply button.

Your settings are saved.

14. To save the settings to the running configuration, click the Save icon.

Main User Manual

874

Monitor the Switch and Network

Fully Managed Switches M4350 Series Main User Manual