NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 235)

After a port or an Auto-LAG becomes an Auto-Trunk, all VLANs on the switch become
part of the trunk, and all VLANs on the switch and the partner device can be configured
automatically.
Enable or disable Auto-Trunks
By default, the Auto-Trunk feature is globally enabled but you can globally disable it.
To enable or disable Auto-Trunks:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching> VLAN > Advanced > VLAN Trunking Configuration.
The VLAN Trunking Configuration page displays.
6. In the Global Auto-Trunk Mode section, select the Admin Mode Enable or Disable
radio button.
By default, the Auto-Trunk feature is globally enabled.
7. Click the Apply button.
Your settings are saved.
8. To save the settings to the running configuration, click the Save icon.
Configure the switch port mode settings for
interfaces
You can configure switch port mode settings on interfaces. The switch port mode defines
the purpose of the port based on the type of device it connects to and constraints the
Main User Manual 235 Configure Switching Information
Fully Managed Switches M4350 Series Main User Manual