NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 399)

The System Information page displays.
5. Select Routing > IP > Basic > IP Configuration.
The IP Configuration page displays.
6. Select the Routing Mode Enable or Disable radio button.
This selection enables or disables the administrative mode for IPv4 routing for the
switch. The default is Enable.
7. Select the ICMP Echo Replies Enable or Disable radio button.
The default is Enable, which means that the switch sends ICMP echo replies to ICMP
echo requests.
8. Select the ICMP Redirects Enable or Disable radio button.
The default is Disable. If you enable ICMP Redirects, the switch can forward ICMP
Redirects.
9. In the ICMP Rate Limit Interval field, specify the number of ICMP error packets that
are allowed per burst interval.
By default, the burst interval is 1000 msec (the rate limit is 100 packets/sec). The
interval is from 0 to 2147483647 msec. Enter 0 to let the switch ignore the number
of ICMP error packets that are allowed per burst interval.
10. In the ICMP Rate Limit Burst Size field, specify the number of ICMP error packets
that are allowed for the burst size.
By default, the burst size is 100 packets. The burst size range is from 1 to 200. Enter
0 to let the switch ignore the number of ICMP error packets that are allowed for the
burst size.
11. To configure a global default gateway, select the Select to configure Global Default
Gateway check box. Then, in the Global Default Gateway field, enter the IP address.
The default gateway that you specify receives a higher preference than a default
gateway that is learned from a DHCP server. You configure one default gateway
only, but you can change the default gateway.
12. Click the Apply button.
Your settings are saved.
13. To save the settings to the running configuration, click the Save icon.
The following table describes the view-only fields on the page.
Main User Manual 399 Manage Routing
Fully Managed Switches M4350 Series Main User Manual