NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 32
graphic also provides information about device ports, current configuration and status,
tables, and feature components.
To use the Device View:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select System > Device View.
The Device View front view of the switch displays. If a stack is configured, the front
view of each stacked switch displays.
The port coloring indicates the port status:
•
Black: The port is disabled or not connected to a device.
•
Green: The port is connected to a device.
•
Gray: The port is detached. For example, a port is detached if it is configured as
a stack port but not connected to a stack member.
•
Red: An error occurred on the port.
The port LEDs indicate the port status and the system LEDs indicate the system
status. For more information about the LEDs, see the hardware installation guide,
which you can download by visiting .
6. To display the back view, click the B button, and to display the front view again, click
the F button.
If the front view displays, the B button displays so that you can switch to the back
view. If the back view displays, the F button displays so that you can switch to the
front view.
7. To display the menus that let you configure ports, point to a port and right-click the
port.
Main User Manual
32
Get Started with the Main UI
Fully Managed Switches M4350 Series Main User Manual