NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 143)

The System Information page displays.
5. Select System > Services > DHCP L2 Relay > DHCP L2 Relay Global Configuration.
The DHCP L2 Relay Global Configuration page displays.
6. Select the Admin mode Disable or Enable radio button to disable or enable the
DHCP L2 relay on the switch.
The default is Disable.
7. In the DHCP L2 Relay VLAN Configuration section, configure the following settings:
• VLAN ID: The ID of the VLAN that is already configured on the switch.
You cannot use this page to add a VLAN. For information about adding VLANs,
see VLANs on page 229.
• Admin mode: Enable or disable the DHCP L2 relay on the VLAN.
• Circuit ID mode: Enable or disable the circuit ID suboption of DHCP Option-82.
• Remote ID String: Specify the remote ID if the Remote ID option is enabled.
8. Click the Apply button.
Your settings are saved.
9. To save the settings to the running configuration, click the Save icon.
Configure a DHCP L2 relay interface
You can configure a DHCP L2 relay on an interface.
To configure DHCP L2 relay interface:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
Main User Manual 143 Configure Switch System
Information
Fully Managed Switches M4350 Series Main User Manual