NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 275)

The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching > iSCSI > Basic > Global Configuration.
The iSCSI Global Configuration page displays.
6. Select an iSCSI Status radio button:
• Enable: iSCSI is enabled for the switch.
• Disable: iSCSI is disabled for the switch. This is the default setting.
7. Select a QoS Profile radio button and the associated settings:
• VLAN Priority Tag: iSCSI flows are assigned to the highest VLAN priority tag.
From the VLAN Priority Tag menu, select a priority tag in the range from 0 (the
lowest priority) to 7 (the highest priority). The default tag is 5.
• DSCP: iSCSI flows are mapped to the highest DSCP value that is not used for
switch management or a voice VLAN. From the DSCP menu, select a DSCP value
in the range from 0 to 63. The higher the value, the higher the priority. The default
value is 46.
8. Select a Remark radio button:
• Disable: iSCSI frames that leave the switch are not marked with the configured
VLAN priority tag or DSCP value.
• Enable: iSCSI frames that leave the switch are marked (that is, remarked ) with
the configured VLAN priority tag or DSCP value. This is the default setting.
9. In the iSCSI Aging Time field, enter the number of minutes after which an inactive
session is terminated.
The range is from 1 to 43200 minutes. The default is 10 minutes,
10. Click the Apply button.
Your settings are saved.
11. To save the settings to the running configuration, click the Save icon.
Main User Manual 275 Configure Switching Information
Fully Managed Switches M4350 Series Main User Manual