Configure igmp snooping manually – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 309
Table 75. IGMP snooping configuration information
Description
Field
The number of multicast control frames that are processed by the switch.
Multicast Control Frame Count
The interfaces on which IGMP snooping is enabled.
Interfaces Enabled for IGMP
Snooping
Indicates if IGMP snooping is globally enabled or disabled on the switch.
Operational Mode
The VLANs on which IGMP snooping is enabled.
VLAN IDs Enabled For IGMP
Snooping
Configure IGMP snooping manually
You can manually configure the settings for IGMP snooping, which is used to build
forwarding lists for IPv4 multicast traffic.
You can also configure IGMP snooping automatically (see Configure IGMP snooping
automatically with IGMP Plus mode on page 307).
To configure the settings for IGMP snooping manually:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching > Multicast > IGMP Snooping > Configuration.
The Configuration page displays.
6. Select the Admin Mode Enable or Disable radio button.
This selection enables or disables the administrative mode for IGMP snooping for
the switch. The default is Disable.
7. Select the Validate IGMP IP header Enable or Disable radio button.
Main User Manual
309
Configure Switching Information
Fully Managed Switches M4350 Series Main User Manual