NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 697)

• To configure a single interface, select the check box associated with the interface,
or type the interface number in the Go To Interface field and click the Go button.
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the
heading row.
8. Click the Initialize button.
802.1X on the selected port is reset to the initialization state. Traffic sent to and from
the port is blocked during the authentication process. This button is available only
if the control mode is auto. When you click this button, the action is immediate. You
do not need to click the Apply button for the action to occur.
Display the port summary
You can display summary information about the port-based authentication settings for
each port.
To display the port summary:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Security > Port Authentication > Advanced > Port Summary.
The Port Summary page displays.
6. If a stack is configured, select whether to display the physical interfaces for one switch
or for all switches in the stack:
• Unit ID for a stacked switch: The physical interfaces for the switch with the
selected stack unit ID are displayed.
Main User Manual 697 Manage Switch Security
Fully Managed Switches M4350 Series Main User Manual