Configure the global ospfv3 settings – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 490
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > OSPFv3 > Advanced > OSPFv3 Configuration.
The OSPFv3 Configuration page displays. The page shows different sections.
6. Go to the Default Route Advertise Configuration section.
7. Select a Default Information Originate radio button:
•
Enable: OSPFv3 originates a default route for external LSA advertising. This route
is in the format IPv6 address/prefix.
•
Disable: OSPFv3 does not originate a default route for external LSA advertising.
This is the default settings.
8. Select an Always radio button:
•
True: OSPFv3 originates a default route regardless of whether a default route
exists.
•
False: OSPFv3 originates a default route only if a default route is already in the
switch’s routing table.
9. In the Metric field, set the metric value of the default route.
The value ranges from 0 to 16777214. The default is 0.
10. Select a Metric Type field radio button:
•
External Type 1: This metric is computed by adding the internal OSPFv3 cost
to the external redistributed cost.
•
External Type 2: This metric is computed by using only the external redistributed
cost. This is the default.
11. Click the Apply button.
Your settings are saved.
12. To save the settings to the running configuration, click the Save icon.
Configure the global OSPFv3 settings
You can configure the OSPFv3 settings that apply globally to the OSPFv3 processes on
the switch.
Main User Manual
490
Configure OSPF and OSPFv3
Fully Managed Switches M4350 Series Main User Manual