Change a protocol-based vlan group – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 247
The ID must be a number in the range of 1 to 4093. An interface in the group assign
this VLAN ID to untagged packets that the interface receives for the protocols that
you include in this group.
10. Click the Add button.
The protocol-based VLAN group is added.
The Ports field displays the interfaces ports that belong to the group.
11. To save the settings to the running configuration, click the Save icon.
Change a protocol-based VLAN group
You can change an existing protocol-based VLAN group.
To change a protocol-based VLAN group:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching > VLAN > Advanced > Protocol Based VLAN Group
Configuration.
The Protocol Based VLAN Group Configuration page displays.
6. Select the check box for the group ID.
7. Change the settings are needed.
For more information, see Add a protocol-based VLAN group on page 245.
8. Click the Apply button.
Your settings are saved.
9. To save the settings to the running configuration, click the Save icon.
Main User Manual
247
Configure Switching Information
Fully Managed Switches M4350 Series Main User Manual